Task 7 - Final Design of 3D model

These are the images of my final 3D environment. The images fully showcases the different techniques that I used to complete it. You can see my mushrooms that I created using red tissue paper with cardboard stems. Apart from the textures and assets that I annotated from my task 4 post I decided to add some other assets like the rocks and the tree logs. 

For the rocks I used tissue paper and I wanted for them to be grey but there was no grey colored tissue paper available so I improvised and thought of the black and white paint makes grey logic and used both black and white tissue paper by first scrunching up different sizes of the black tissue paper I then scrunched the white tissue paper over the black one and because white tissue paper is a bit see through it allowed for a bit of black to be shown which resulted to them looking grey. 

For the tree logs it was a coincidental idea, because while was creating the stems for the mushrooms I happened to tear off a layer of the card board which revealed that it had ridges underneath and it reminded me of a hollow tree trunk and so once I had set up the all the other pieces I just added them as extra's. 

Also if you look closely at the cardboard there are still some left over layers on it that were I couldn't successfully tear off but then I thought it added some effects to it cause it reminded me of old, hollow, worn down tree trunks. 

I am very happy with the my final 3D model because I didn't think that I would be able to finish it on time but I was able to and I think that I finished in quite a high standard because it consists of many different techniques that have gone through experimentation and improvements.